Skip to main content

windscreen wipers

A topic for such easy subject? Yes, because the windscreen wipers you can buy at your local carparts store are all for the typical modern wiper-arm;

standard modern car
In Russia some things are different..... The wiper arms don't have the "hook" on a Lada 21013, they have a straight end.


I noticed during heavy rainfall that both wipers made an annoying noise.

Not strange when you discover that the clips were held by tie rips...

Instead of going for the usual suspects Bosch, Valeo, SWF, I did visit www.ladapower-europe.com again. Good choice, because these Russian wipers came with the correct clip for the straight Lada 2101 wipers.

Comments

Popular posts from this blog

For sale

Even though we like our little Lada a lot, we know that in the end we need to create some space around the house, so our Lada 1200S is for sale . On this blog you can see the Lada-bid-o-meter for the current asking price. We wrote this blog so you can see what state the vehicle is, and all the work that got into it to get it so far. The name of this blog blablalada  derived from a Dutch TV commercial "Lada, een auto zonder bla bla", which can be translated as "Lada a car without pretenses". Specifications Lada 1200 / AutoVAZ 21013 Year: 1988 Milage: 25.878 km First owner vehicle from 1988 - 2017 Lada-bid-o-meter Asking price: € 4.100,- Email: marco@otoparts.nl LADA for sale / te koop / à vendre / zu verkaufen / in vendita / na sprzedaż This specific vehicle "Lada 1200" is an export version of the 2101. According to Wikipedia: " 21013 (1977–1988) — similar to VAZ-21011, 1,198 cc (73.1 cu in) engine, exported ...

Historical plates

One of the first improvements was replacing the modern yellow EU-license plates for more time approiate historical plates. Simple job.... Untill the moment, that you realise that the modern plates are larger. In fact the yellow plates were screwed to the vehicle with the outer mounting slots. So we now have a lada with 1 hole left to the rear plate, and 1 hole to the right. We will fix that later on. Modern plates are installed with plastic frames, commonly (anti theft) in combination with rivets or screws. For our authentic look we didn't want to dammage the plate on the front surface. We went for PVC blocks, carefully positioned on the rear of the license plate. The PVC blocks are pre-drilled with M6 thread. With the rear now in a more historical look (we also did take off the plastic "katalysator-emblem", it's time to move to the front of the vehicle. Again the original brackets are too wide. So we made new brackets o...

Seat repair

On the "To do list" was the repair of the driver side seat. The reclining function didn't work anymore. Since there were marks of an pipe wrench on the knob, it's probably broken. But first we have to investigate what happened. Removing the Lada 2101 seat slide the seat in the utmost forward position at the rear of both sliding rails is a cross head bolt, unscrew them slide the seat in the utmost backward position on the front of the sliding rails is 1x cross head bolt and 1x a 13mm nut (which you unscrew from below). Functions of the Lada 2101 seat the handle on the centre side of the vehicle has 1 function; move down and you are able to slide the seat the other handle (the big round knob) has got 2 functions; turn the knob and you can fine-adjust the reclining of the back. For function two, you push the knob to the ground, then you get the rapid reclining function of the back And now the reality... * a couple of hours later *, ok... tha...